Change: The hole center is 2 7/8" high from the bucket floor and 5 7/8" horizontal distance from the bucket cutting edge.Then I used the mounting washer (supplied) to mark the circle for the hole. 5. To cool the drill I used a   View changes from previous version. (Word count: 624)

Change: There were only format changes (bold, italics, etc.) in this version. See this version for details. (Word count: 600)

Change: 5. To cool the drill I used a tablespoon of motor oil sitting in a bottle top. I first drilled a pilot hole with a   View changes from previous version. (Word count: 537)

Change: of W R Long Flat Tooth Bar on BX24 1. The tooth bar was shipped unpackaged, with shipping labels on the bar. It's nominally 48" but you need to provide the inside bucket dimension when ordering. In my case 46.5". I arranged a pair of   View changes from previous version. (Word count: 270)

Change: It retained this position while I marked the holes - so I did not need a second pair of hands to hold it. Using a felt pen markedI traced the slot'smounting slot front(front edgehalf) on the bucket wall. If you don't drill atmountusing the front   View changes from previous version. (Word count: 257)

Change: Created by apmillard May 3 2008, 11:28 PM EDT for: no reason given