Thread started: Oct 1 2008, 6:15 AM EDT
Watch
I just did my 50 hour maintenance on my BX24. Has anyone else had issue with the published capacity of the transmission? I spilled a bit of UDT trying to fill the puppy.
I have skid plates on (LOVE them), and was able to remove/replace the oil and transmission filters without removing them. I used a wrench to loosen them. You need to take off the right-rear wheel to get to the transmission filter.
1
out of
1 found this valuable.
Do you find this valuable?
Do you?
Show Last Reply
|
Last Reply:
RE: BX24 50-hour maintenance
By: MartyJackson,
Jan 11 2010, 3:33 PM EST
My kubota dealer said to be carefull when using other hydraulic fluids when servicing the bx line they call for a full synthetic oil due to the high rpms and heat it will endure. using the regular hydraulic fluid will cause an overheating problem in the tranny. The kubota synthetic fluid was not cheap but you allready spent $16000 on the machine so I figure whats another $100. And they said to check the fluids in the ground level posistion on the loader and with the boom pinned on the rear. I hope this can help.
out of
found this valuable.
Do you find this valuable?
|
