Thread started: Feb 1 2009, 9:57 PM EST
Watch
When i built the same tester gauge set to check my hydraulic pressure, it was only 1700PSI, added (1) shim = to .014" increased pressure to 1845PSI. this was checked at operating temperatures.
Reason for testing was that I felt the FEL was not as strong as when first brought home.. Pressure was low than spec. after operating for 100 hrs.
3
out of
3 found this valuable.
Do you find this valuable?
Do you?
Show Last Reply
|
|
Last Reply:
RE: Hydraulic found below specs
By: ,
Jan 11 2010, 3:53 PM EST
Hi I was wondering where the shims are ? Are they on the relief valve? I have the same problem. I have not looked into it to far yet. Thanks
out of
found this valuable.
Do you find this valuable?
|
